MPA

Product code MPA
Category Surface pumps Self - Priming
Brand SOVESI Water Pumps
Attachments:

Operating data

Tip a friend

More questions ?

Users vote (128)

Selfpriming water pumps for deep suctions up to mt. 35 to be used in case of important water level gaps. Suitable to drain water from wells and in domestic fittings by small and medium sized tanks. Before installing the pump verify that all pipes (iron, plastic or rubber) are clean inside so to avoid any obstruction to the ejector nozzle. At the foot of the ejector must be installed a foot valve or a check valve. Installed the pump, fill completely both pipes and pump body with clean water. To preserve an efficient priming it is necessary a certain pression in the circuit, therefore it is recommended to install a membrane tank at the delivery of the pump.

 

OPERATING CONDITIONS

- Liquid temperature up to 35°C

- Ambient temperature up to 40°C

- Total suction lift up to 35 mt.

- Continuous duty

 

MOTOR

- Two-Pole induction motor (n = 2850 min-1)

- Insulation Class F

- Protection IP 44

 

MATERIALS

- Pump body Cast Iron

- Motor support Cast Iron

- Impellers Noryl

- Diffuser Noryl

- Ejector Cast Iron

- Shaft with rotor Stainless Steel AISI 304

- Mechanical seal Ceramic/Graphite/NBR

Registered users can share their experience with this product. Register to access all of the benefits reserved to registered users or click on login if you are already registered.